The MixRack is the heart of any dLive system. It houses the XCVI processing core complete with audio I/O, control and audio networking ports. It is typically connected to a dLive Surface, but can also be controlled at the same time as or even without a Surface using a laptop or iPad, Allen & Heath IP remotes or third party controllers via TCP/IP.
There are different sizes of dLive MixRack available. All feature the same mix engine and can work with the full 128 channels by adding DX expanders or digital sources.
The MixRack is the heart of any dLive system. It houses the XCVI processing core complete with audio I/O, control and audio networking ports. It is typically connected to a dLive Surface, but can also be controlled at the same time as or even without a Surface using a laptop or iPad, Allen & Heath IP remotes or third party controllers via TCP/IP.
There are different sizes of dLive MixRack available. All feature the same mix engine and can work with the full 128 channels by adding DX expanders or digital sources.
INPUTS | |
Mic/Line XLR Inputs | Balanced XLR, +48V phantom power |
Mic/Line Preamp | Fully recallable |
Input Sensitivity | -60 to +15dBu |
Analogue Gain | +5 to +60dB, 1dB steps |
Pad | -20dB Active PAD |
Maximum Input Level | +30dBu (PAD in) |
Input Impedance | >4kΩ (Pad out), >10kΩ (Pad in) |
Mic EIN | -127dB with 150Ω source |
Phantom Power indication | Per socket, internal or external phantom power sensing, triggered at 24V |
OUTPUTS | |
Analogue XLR Outputs | Balanced, Relay protected |
Output Impedance | <75Ω |
Nominal Output | +4dBu = 0dB meter reading |
Maximum Output Level | +22dBu |
Residual Output Noise | -92dBu (muted, 20-20kHz) |
-90dBu (muted, 20-40kHz) | |
SYSTEM | |
Measured balanced XLR in to XLR out, 20-20kHz, minimum Gain, Pad out, signal @ 0dB (meter) | |
Dynamic Range | 110dB |
System Signal to Noise | -92dB |
Frequency Response | 20Hz - 30kHz +0/-0.8dB |
THD+N (analogue in to out) | 0.0015% @ +16dBu output, 1kHz 0dB gain |
Headroom | +18dB |
Internal operating Level | 0dBu |
dBFS Alignment | +18dBu = 0dBFS (+22dBu at XLR output) |
Meter Calibration | 0dB meter = -18dBFS (+4dBu at XLR out) |
Meter Peak indication | -3dBFS (+19dBu at XLR out) |
Sampling Rate | 96kHz +/- 20 PPM |
ADC | 24-bit Delta-Sigma |
DAC | 24-bit Delta-Sigma |
Latency | 0.7 ms (MixRack XLR in to XLR out, Input to Mix) |
+ 5 samples, Surface to Mixrack (GigaACE hop) | |
+ 8 samples, DX32 to Mixrack (DX hop) | |
DIMENSIONS & WEIGHTS | |
CDM32: | |
Width x Depth x Height x Weight | 481.6 x 309 x 221 mm 5U (19"x 12.2"x 8.7") x 10kg (22lbs) |
CDM32 - boxed: | 600 x 430 x 380 mm (23.6"x 16.9"x 15") x 12kg (26.5lbs) |
Operating Temperature Range | 0 deg C to 35 deg C (32 deg F to 95 deg F) |
Mains Power (MPS16) | 100-240V AC, 50-60Hz, 175W max |