The MixRack is the heart of any dLive system. It houses the XCVI processing core complete with audio I/O, control and audio networking ports. It is typically connected to a dLive Surface, but can also be controlled at the same time as or even without a Surface using a laptop or iPad, Allen & Heath IP remotes or third party controllers via TCP/IP.
There are 3 sizes of dLive MixRack available. All feature the same mix engine and differ only in the number of analogue I/O. All models can work with the full 128 channels by adding DX expanders or patching digital sources.
The MixRack is the heart of any dLive system. It houses the XCVI processing core complete with audio I/O, control and audio networking ports. It is typically connected to a dLive Surface, but can also be controlled at the same time as or even without a Surface using a laptop or iPad, Allen & Heath IP remotes or third party controllers via TCP/IP.
There are 3 sizes of dLive MixRack available. All feature the same mix engine and differ only in the number of analogue I/O. All models can work with the full 128 channels by adding DX expanders or patching digital sources.
INPUTS | |
Mic/Line XLR Inputs | Balanced XLR, +48V phantom power |
Mic/Line Preamp | Fully recallable |
Input Sensitivity | -60 to +15dBu |
Analogue Gain | +5 to +60dB, 1dB steps |
Pad | -20dB Active PAD |
Maximum Input Level | +30dBu (PAD in) |
Input Impedance | >4kΩ (Pad out), >10kΩ (Pad in) |
Mic EIN | -127dB with 150Ω source |
Phantom Power indication | Per socket, internal or external phantom power sensing, triggered at 24V |
OUTPUTS | |
Analogue XLR Outputs | Balanced, Relay protected |
Output Impedance | <75Ω |
Nominal Output | +4dBu = 0dB meter reading |
Maximum Output Level | +22dBu |
Residual Output Noise | -92dBu (muted, 20-20kHz) |
-90dBu (muted, 20-40kHz) | |
SYSTEM | |
Measured balanced XLR in to XLR out, 20-20kHz, minimum Gain, Pad out, signal @ 0dB (meter) | |
Dynamic Range | 110dB |
System Signal to Noise | -92dB |
Frequency Response | 20Hz - 30kHz +0/-0.8dB |
THD+N (analogue in to out) | 0.0015% @ +16dBu output, 1kHz 0dB gain |
Headroom | +18dB |
Internal Operating Level | 0dBu |
dBFS Alignment | +18dBu = 0dBFS (+22dBu at XLR output) |
Meter Calibration | 0dB meter = -18dBFS (+4dBu at XLR out) |
Meter Peak indication | -3dBFS (+19dBu at XLR out) |
Sampling Rate | 96kHz +/- 20 PPM |
ADC | 24-bit Delta-Sigma |
DAC | 24-bit Delta-Sigma |
Latency | 0.7 ms (MixRack XLR in to XLR out, Input to Mix) |
+ 5 samples, Surface to Mixrack (GigaACE hop) | |
+ 8 samples, DX32 to Mixrack (DX hop) | |
POWER | |
Mains Voltage Operating Range | 100-240V AC, 50/60Hz |
Mains Power Consumption | 300W max (MPS16 V1 300W)* |
250W max (MPS16 V2 250W)* | |
* MPS16 power consumption is printed under AC inlet | |
TEMPERATURE | |
Operating Temperature Range: | |
Fitted with MPS16 V1 300w | 0°C to 35°C (32°F to 95°F) |
Fitted with MPS16 V2 250w | 0°C to 40°C (32°F to 104°F) |
DIMENSIONS & WEIGHTS | |
DM32: | |
Width x Depth x Height x Weight | 482.6 x 313 x 325 mm (19"x 12.3"x 12.8") x 15kg (33lbs) |
DM32 - boxed: | |
Width x Depth x Height x Weight | 590 x 420 x 470 mm (23.2"x 16.5"x 18.5") x 17.5kg (38.6lbs) |